Scope Respiratory

Scope Respiratory is part of Sleepscope

Sleepscope runs lung function tests and respiratory consultations as well as sleep studies.

Continue to Sleepscope Sleepscope
More information

Lung Function Test

Book your Lung Function Test Call 1800 202 111

What does a lung function test measure?

A lung function test is a set of breathing tests that measures how well your lungs are working. It allows your doctor to check:

During the test, you breathe through a mouthpiece connected to a machine that measures your breathing. The test is non-invasive, with nothing entering your body other than the air and test gas you breathe in. The results can help your doctor diagnose respiratory conditions and monitor how well your treatment is working.

Need urgent care?

Call triple zero (000) immediately if you are short of breath and any of these apply: you cannot speak in full sentences, you have pain in your chest, arm, or jaw, your skin is pale and sweaty, your lips are blue, or you feel drowsy or confused.

Do not wait for a routine appointment or drive yourself to hospital.

Why your doctor may request a lung function test

Your GP or specialist may request a lung function test if you have:

Spirometry before and after medication

Spirometry measures how much air you can breathe in and blow out, and how fast. It is done first without any medication (pre-bronchodilator), then again after a bronchodilator such as Ventolin, which helps open your airways (post-bronchodilator). Comparing the two shows how much the medication improves your lung function.

Gas transfer test

The gas transfer test shows how well oxygen moves from your lungs into your bloodstream. The machine measures how much of a test gas your lungs absorb while you hold your breath.

About 30 minutes

Three parts in one visit

Stop some inhalers

Up to 48 hours before

Guided throughout

Staff talk you through each step

What happens during the appointment

  1. Getting started: Please arrive 10 to 15 minutes early to complete the forms. The test takes about 30 minutes, and our team will talk you through each step.
  2. Spirometry before medication: You will breathe normally through a mouthpiece connected to the machine, while wearing a nose clip. Then you will take a deep breath in and blow out as hard and fast as possible until your lungs are empty, followed by a fast, full breath in. You will repeat this several times to obtain accurate and consistent results.
  3. Gas transfer test: You will breathe in a test gas through the mouthpiece, hold your breath for about 10 seconds, then breathe out completely. You may be asked to repeat this a few times, with short breaks in between.
  4. The bronchodilator: You will be given a bronchodilator, such as Ventolin, to help relax and open your airways. You will then wait about 5 to 10 minutes for the medication to take effect.
  5. Spirometry after medication: You will repeat the spirometry, so we can see how much the medication has improved your lung function.
  6. Wrap up: You can go straight back to your usual routine, and your results will be sent to your referring doctor.

Please note: You may feel temporarily short of breath or dizzy, or cough during the test, and these symptoms usually go away quickly. In rare cases, deep breathing might trigger symptoms in people with asthma, and our team is prepared to help if this happens.

If you've been referred to Sleepscope

Sleepscope accepts referrals from all GPs and specialists. Please bring your referral letter to your appointment. If you are not sure whether you need one, or why you have been referred, please ask the doctor who is arranging your test.

Fees

For the latest fees, see the page for your clinic under Our Locations.

Understanding your results

Your results will be sent to your referring doctor promptly, and your doctor will go through the findings with you.

Preparing for the appointment

To make sure we get accurate results, please follow these preparation guidelines. The same preparation applies to spirometry and the gas transfer test, which are part of a lung function test.

Medications

Some lung medications, such as inhalers, need to be stopped before the test.

If you are unsure about any of your medications, please contact Sleepscope before your test.

On the day

Please note that only 1 person will be allowed into the appointment room due to space constraints. Family, children, guardians, friends and carers will only be allowed in if it's absolutely necessary. A language interpreter can come in with you.

Please tell us before your test if you have recently had:

If you need to cancel or reschedule, please give us at least 48 hours' notice.

What to bring

What it looks like

A short look at the mouthpiece, the machine and what each of the three parts of the test involves.

Frequently asked questions

Does Sleepscope perform a lung function test?

Yes. A lung function test is available at selected Sleepscope clinics. Each clinic's page under Our Locations lists the tests it offers.

Is a lung function test the same as spirometry?

No. Spirometry is one part of a lung function test. The test also includes a gas transfer test, which shows how well oxygen moves from your lungs into your bloodstream.

Does a lung function test hurt?

Most people feel nothing at all, as nothing enters your body other than the air and the test gas you breathe in. You may feel temporarily short of breath or dizzy, or cough during the test, and these symptoms usually go away quickly.

How long does it take?

About 30 minutes for the three parts together. Please arrive 10 to 15 minutes early to complete the forms.

Can I take my medication as usual?

Not all of them. Some inhalers need to be stopped 6 to 48 hours before the test, depending on the medicine, as listed under Preparing for the appointment. Please take your other medications as usual.

Can I go back to my usual routine afterwards?

Yes. You can go straight back to your usual routine after the test.